Kenmore Elite 42563 Bedienungshandbuch PDF herunterladen (Seite 13)

Before Setting Oven Controls

Oven vent location

The oven vent is located under the control panel (Figure 16).

When the oven is on, warm air passes through this vent. Steam

or moisture may appear near the oven vent, this is normal. This

venting is necessary for proper air circulation in the oven and

good baking results. Do not block oven vent:

Always use pot holders or oven mitts when

using the oven. When cooking, the oven interior and exterior,

oven racks and cooktop will become very hot which can cause

burns. Remove all racks before using the self clean function.

Protective Liners — Do not use aluminum foil to

line the oven bottom, racks, walls or any part of the oven. Only

use aluminum foil as recommended in this manual. Improper

installation of these liners may result in risk of electric shock, or

fire.

Removing, replacing, and arranging flat or offset oven racks

•To arrange - Always arrange the oven racks when the oven

is cool (prior to operating the oven).

•To remove - Pull the oven rack straight forward until it

reaches the stop position. Lift up front of oven rack slightly

and slide out.

•To replace - Place the oven rack on the rack guides on both

sides of oven walls, tilt upward slightly and slide the oven

rack back into place. Be sure oven racks are level.

Types of Oven Racks

The flat oven rack (some models) or flat handle oven rack (some

models) may be used for most cooking needs. The offset oven

rack (on some models) is designed to place the base of the rack

about 1/2 of a rack position lower than flat oven racks.

The Glide rack (some models) allows you to easily slide

bakeware in and out to check food or to remove or place items

while firmly holding even heavier items in place. The rack is held

in place securely and will not extend beyond the glide stop

position unless it is released manually.

To remove the Glide rack for cleaning or when performing a

self clean cycle.

1. Grasp the locking bar beneath the handle as shown in

Figure 18. Pulling up on this bar unlocks the rack.

2. When the lock is released, pull the rack towards you until it

stops (Figure 19).

3. Grasp the Glide rack on both sides and gently lift it up to

allow the rack to move past the stop position (Figure 20)

and remove the rack. To replace, set the Glide rack into the

desired rack position by using the directions in step 3 in

reverse.

Air circulation in the oven

For best air circulation when baking, allow a space of 2 inches

(5 cm) around the bakeware for proper air circulation. Be sure

pans and bakeware do not touch each other, the oven door,

sides, or back of the oven cavity. Hot air must be able to

circulate around bakeware for even heat to reach the food.

Figure 16: Oven vent location

Figure 17: Variety of oven racks

at oven rack

at handle

oven rack

oset

oven rack

Glide

Rack

Figure 18: Releasing Glide rack lock

Figure 19: Pulling Glide rack to stop position

Figure 20: Correct angle for removing or inserting the Glide

rack.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 39 40

Kommentare zu diesen Handbüchern

Keine Kommentare

Kenmore Elite 42563 Bedienungshandbuch Seite 13

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Mikrowellen Kenmore Elite 42563