Kenmore Elite 81714 Bedienungshandbuch PDF herunterladen (Seite 21)

- 21 -

2. Place agitator

assembly back

into PowerMate

TO REPLACE BELT

1. Install new belt over motor shaft, then

over belt path.

NOTE: See PARTS AND FEATURES for Belt

number (page 5).

4. Line up front of cover and base. Rest

cover on front edge of base as shown.

5. Rotate cover back. Press cover 

until side and rear latches snap into place.

NOTE: Make sure there is no gap between

the cover and base.

6. Turn PowerMate

upside down and

replace six (6) cover screws.

End Cap

Belt Path

Brush Unit

TO CLEAN AGITATOR:

NOTE: In order to keep cleaning 

high and to prevent damage to your vacu-

um cleaner, the agitator must be cleaned

every time the belt is changed.

The agitator must also be cleaned accord-

ing to the following schedule:

Vacuum Cleaner Use Clean Agitator

HEAVY - every week

(used daily)

MODERATE - every month

(used 2-3 times/week)

LIGHT - every 2 months

(used 1 time/week)

IMPORTANT

Trom

electrical outlet. Check and remove hair,

string and lint build-up frequently in the

PowerMate

agitator and end cap areas.

Remove any dirt or debris in the belt path

area or in the brush roller area.

Carefully remove any string or debris

located on the agitator or end caps.

AGITATOR ASSEMBLY

3. Reinstall agitator cover. Make sure there

is no gap between the agitator cover and

base.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 47 48

Kommentare zu diesen Handbüchern

Keine Kommentare

Kenmore Elite 81714 Bedienungshandbuch Seite 21

Kommentare zu diesen Handbüchern